AquaRank.com

FishProfiles.com Message Forums

faq | etiquette | register | my account | search | mailbox
# FishProfiles.com Message Forums
L# General
 L# The Hospital
  L# Angelfish - Not looking the Same
 Post Reply  New Topic
SubscribeAngelfish - Not looking the Same
tetratech
----------
Ultimate Fish Guru
Posts: 4241
Kudos: 1074
Registered: 04-Nov-2003
male usa
I've had this big angel in my 46gallon planted for about 1 year. He has grown from smaller than a dime to large than a silver dollar. Usually eating everything in site and harassing another angel I have. The last few days I noticed he looks kinda flush almost with a red glow. He's a marble angel. I especially noticed red where his pectoral fin meets the body.

The only thing I've been doing differently is adding co2, but my kh is 3 and ph is 7. Any ideas.

My Scapes
Post InfoPosted 26-Jan-2006 11:36Profile PM Edit Report 
ACIDRAIN
 
---------------
---------------
Moderator
Posts: 3162
Kudos: 1381
Votes: 416
Registered: 14-Jan-2002
male usa us-ohio
What is your other levels? NitrAte and ammonia specifically?

_____________________________________________________________

There is always a bigger fish...
Post InfoPosted 26-Jan-2006 11:36Profile PM Edit Delete Report 
tetratech
----------
Ultimate Fish Guru
Posts: 4241
Kudos: 1074
Registered: 04-Nov-2003
male usa
NitrAte and Ammonia are nil. All the other fish seem fine.
Within the past 24 hrs I did put together a co2 cocktail of:

Sugar
Yeast
Baking Soda
Protein Drink Mix

I just did a 20% water change. He seems to be hanging out at the filter return.



My Scapes
Post InfoPosted 26-Jan-2006 11:36Profile PM Edit Delete Report 
ACIDRAIN
 
---------------
---------------
Moderator
Posts: 3162
Kudos: 1381
Votes: 416
Registered: 14-Jan-2002
male usa us-ohio
If you have been newly adding CO2, this may be the problem. For two reasons. How much are you adding, and how much surface aggition do you have. You may be putting in too much CO2 and poisoning your fish. Also, with that low hardness and ph, you could be getting a ph swing at night, as the plants will start to use O2, and produce CO2, and thus causing an even greater influx of CO2. High levels of CO2 with low hardness, and neutral to low ph, can cause the ph to drastically swing one way, and back the next time the lights are on and the plants go back to producing O2. You should check your ph and your CO2 levels about 2 hours before the tank gets any light. And see if they are changed much.

Your first description sounds like either Ammonia, NitrAte, or CO2 poisoning. But, may be ph burn.

_____________________________________________________________

There is always a bigger fish...
Post InfoPosted 26-Jan-2006 11:36Profile PM Edit Delete Report 
tetratech
----------
Ultimate Fish Guru
Posts: 4241
Kudos: 1074
Registered: 04-Nov-2003
male usa
Acidrain thanks for all the good advice. My co2 seems minimal during the day, but I haven't check anything with the lights off. So I'll try that first thing in the morning. NH3,N02,N03 are all nil basically.

My Scapes
Post InfoPosted 26-Jan-2006 11:36Profile PM Edit Delete Report 
Post Reply  New Topic
Jump to: 

The views expressed on this page are the implied opinions of their respective authors.
Under no circumstances do the comments on this page represent the opinions of the staff of FishProfiles.com.

FishProfiles.com Forums, version 11.0
Mazeguy Smilies